white pandigital novel trouble installing update
Hello I just received the white pandigital novel christmas and I noticed there was a new firmware update on their website I was able to download the update. When I turned my novel off and then turned it back on by holding the power and volume + button for 5 secs like told I get the little guy and the progress bar for like 2 seconds and then the bar goes away and my novel has the little robot with a triangle around a ! and it seems to be frozen. If anyone could help me out that would be great. I am not really sure what to do.
One more thing it shows on the website and the box that when you turn the novel on its side it should show a clock and the main tool bar at the bottom but mine will not do that. On the main page it stays in the vertical position even when docked. Any help on that to would be great.
12-31-2010 08:16 PM
Can you reset the unit and get back to the original firmware? Are you sure the downloaded file is different than the one already on the unit? You might try two or three times with the new firmware, I've had it fail then take the next time.
I got the same thing, the little robot with the Triangle !. This was after my updated firmware. Now I can not get it to turn off. Have done the reset button, did not work. Still on with the little robot, this has been hours ago. If you find out what to do let me know.
Originally Posted by mcwife98
Try pulling the battery plug for a few minutes, should shut it off, then ? on what you will find. May revert to original or you might need to reflash with original or downloaded version and see how it goes.
i refreshed and went back to black screen but it wont turn on again i tried plugging it back in to re do firmware update & it started process but says it cant read or find my pd ereader. i am in tears.
What firmware are you trying to install? If open platform, did you read the instructions?
Don't fret, it is near impossible to brick on of these.
Some possible answers.
Download the firmware again and try it.
Try flashing an older version of firmware.
reset with paper clip
I had the same image, locked up.... I just pushed the little reset hole with a paperclip, seems fine now.
I had that happen too & did the pinhole refresh. Worked perfect. Now however my pinhole does not work. I use tweezers and unplugg the batt plug. CAREFULLY. I did the 11/19 EXTERNAL CARD hack last week and it's awesome
Last edited by fran76; 02-03-2011 at 10:19 PM.