scree problems-is it g sensor or touchscreen..how do i adust???
I'm having problems, my m703 screen is wobbling all over the place. I've tried touch calibration which works or seems to for a minute or two but then I can't do anything. As soon as I touch ormove the tab it goes haywire & needs to be turned off for a while. Could it be g-sensor or is it just a dodgy sceen? I use it fairly heavily & its running uberoid v10 if this helps.
Sent from my WM8650 using Android Tablet
03-22-2012 03:35 AM
hi, sounds bad, maybe you should try a different version software. there is a version v10.1, or higher which i am looking for so far no luck. am kind of lost and just going page by page. Wish i could help you more.
I saw a post a while back where similar behavior was caused by a dirty screen. It thought it was being touched even when it wasn't. If it does it when the tablet's laying down on a table or something where it isn't being moved, that would seem to eliminate the g-sensor.
|If it's important to you, you'll find a
way. If not, you'll find an excuse.
If you're too busy for friends,
You're too busy.
|Attention lurkers! Join the forum,
and enter Spider into the referrer
field of the application.The $0.00
USD fee will be waived.
|People will forget what you said.
People will forget what you did.
But, people will never forget
how you made them feel.
I removed the screen protector & reflashed uberoid 10.1. Works fine now but screen will get scratched. Gettin new device so not so important now.
Sent from my M9701 using Android Tablet