need help superpad 6 stuck on android screen

Discussion in 'SuperPAD II Firmware' started by golfbillbob, Jun 17, 2012.

  1. golfbillbob

    golfbillbob Member

    Joined:
    Jun 9, 2012
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    60
    Location:
    United States
    Tablet / Device:
    super pad 6
    running 4.0 ics i tried to reset my tablet wow what a mistake that was now all i get is the word android running across the screen but first all i got was how to set up your touch screen you know those little circles with the x in the middle it was struck on that for about an hour i kept playing with the buttons now i got nothing but the android name going across my screen i am going to let my battery run all the way down than try to recharge i hope that might work:D i also never got no manual for this Chinese dont never never buy from china they never answer you back tried for a week learn my lesson there:confused: so i need some real help here thanks i tried android for dummies but i could not understand it i must be dumber than dummies.
     
  2. leeb

    leeb Member

    Joined:
    Jul 16, 2011
    Messages:
    463
    Likes Received:
    21
    Trophy Points:
    87
    Okay... (whew!)
    1st things first... notice how I broke it up so I could read it? :rolleyes:
    Lets take the bold pieces one-at-a-time...
    First? The touchscreen calibrate shows up AFTER the 'android' the first time... or if you re-run it.
    You TOUCH THE SCREEN INSIDE THE 'x-circles' UNTIL YOU FINISH UP ON THE CENTER ONE...
    If you touch it outside the circles it will ask you to try again.
    Playing with the buttons... doesnt work for touch calibration... and often causes the havoc youve seen.
    Unsure which 'version' youre working with, but the combination of the front 'back' button AND the <HOME> button held down AT THE SAME TIME as you press the <POWER> button usually shows a message about entering the keys for reset... where you would release the power and, say, home... then press <HOME> again.

    IF things go well, it will say that it is doing a factory restore... then start over, ending up at the touch calibration again.

    If it is a different method, I dont know it..
    Good luck! :D
     

Share This Page

Search tags for this page
android tablet stuck on calibration screen
,
superpad 6 stuck on android screen
,
superpad 7 stuck on android logo
,
superpad 7 stuck on boot
,

superpad 7 will not get past android screen

,
superpad stuck at logo
,
superpad stuck on android
,
superpad stuck on android screen
,
superpad vi stuck on android
,
superpad vi stuck on android screen
,
tablet stuck on android word