[Question] IUS special version for FT3/SP2?

Discussion in 'SuperPAD II Firmware' started by leeb, Sep 24, 2011.

Thread Status:
Not open for further replies.
  1. leeb

    leeb Member

    Joined:
    Jul 16, 2011
    Messages:
    463
    Likes Received:
    21
    Trophy Points:
    87
    As stated in the title, is there a special version of the IUS (IUW) software for the newer pads?

    I have acquired the 'guts' of an FT3/SP2 but do not yet have the 'different' screen...
    In an attempt to confirm that it is operable, I have tried to connect it to the IUW 1.x software I have available and working for my FT2/SuperPAD... but the <MENU><PWR> combo does not get it connected to the PC.

    Is there a different combo for OTG connections on these pads?
    Is there a different version of the IUW software for the newer pads?

    Am I wasting my time? :cool:

    :D
     
  2. mirushaki

    mirushaki Member

    Joined:
    Oct 23, 2012
    Messages:
    5
    Likes Received:
    1
    Trophy Points:
    62
    Location:
    Georgia
    Tablet / Device:
    SuperPad III P001
    Which USB port are you using? OTG connection is available from upper USB port of the PAD. Use IUW 1.2. I have tried many times to find correct .ius file for mu superpad III with no success.
     
    • Like Like x 2
  3. leeb

    leeb Member

    Joined:
    Jul 16, 2011
    Messages:
    463
    Likes Received:
    21
    Trophy Points:
    87
    Thanks for the input... but this is seriously-old news...
    and the board in question was DOA... or I killed it... either way it wont work.
    I already have... 2....3... or so to replace it. :rolleyes:

    :D
     
Thread Status:
Not open for further replies.

Share This Page