Trouble recognising viewpad 10s in Windows 7 64bit

Discussion in 'Advent Tablets' started by JMo15, Mar 29, 2011.

  1. JMo15
    Offline

    JMo15 Junior Member

    Joined:
    Mar 25, 2011
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Wellington NZ
    Tablet / Device:
    No 'Droid device just yet :(
    Hi guys, Just bought an advent vega but branded a viewsonic viewpad 10s... Just spent two days trying to get a male to male usb cable (GRRRR) only to find that my laptop recognises nothing at all... Its in debug mode because i wish to install the modaco custom rom.

    It doesnt even make that little noise when you plug in or remove a usb

    There is nothing under USB devices, nothing under Other Devices, nothing under connected hardware... nothing!! Ive downloaded USBdeview and that doesnt even show it!

    Ive searched modaco forums also.

    Any ideas??
  2. JohanMeert
    Offline

    JohanMeert Junior Member

    Joined:
    Mar 19, 2011
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Belgium
    Tablet / Device:
    Viewpad 10s
    Getting it to recognise is no problem in windows 7, installing the correct USB driver is however NOT working.
    Vista 64bit is working, now i'm going to test XP-mode in win 7

    make sure that:
    - usb-usb cable
    - set the DEBUG mode to ON in your tablet settings
    - power off tablet
    - CONNECT your power supply to the tablet
    - Press and release in sequence the 2 buttons: back - power - power off - back off
  3. beegee_tokyo
    Offline

    beegee_tokyo Junior Member Developer

    Joined:
    Feb 8, 2011
    Messages:
    72
    Likes Received:
    3
    Trophy Points:
    0
    Location:
    Japan
    Tablet / Device:
    WSL XVision (aka Advent Vega)

Share This Page