Pinout for Superpad LCD Connector

Discussion in 'Gome Flytouch II' started by Superpad, Jan 10, 2012.

  1. Superpad

    Superpad Member

    Joined:
    Jan 10, 2012
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    60
    Location:
    Roanoke Va
    Tablet / Device:
    Superpad
    Hello, I have a Superpad that will only power on the screen when you press on the back in the center of the tablet.

    Upon getting it apart and checking a few things I found a broken wire on the LCD cable.

    The problem is I am unsure where it went, because all the pins in the connector have wires attached to them.
    Therefore, either I have lost the pin out of the connector or one terminal was double crimped with two wires.

    Does anyone have a pinout for the LCD cable for the end that connects to the tablet circuit board?
    or if somone has their pad apart could you grab me a close up photo of the wires at the back of the connector.

    Option three would be buying a new cable if someone could tell me where to get it at.

    Thanks
     
    Last edited: Jan 10, 2012
  2. Superpad

    Superpad Member

    Joined:
    Jan 10, 2012
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    60
    Location:
    Roanoke Va
    Tablet / Device:
    Superpad
    I have taken some pictures of the connector in question.
    $P1010027.JPG $P1010028.JPG $P1010033.JPG

    Shown in the 2nd picture is the loose wire. I am wondering if the red wire on the bottom right in picture 2 was double crimped with it.

    Can anyone snap a picture of their superpad cable? Any information will be greatly appreciated.
     
  3. Superpad

    Superpad Member

    Joined:
    Jan 10, 2012
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    60
    Location:
    Roanoke Va
    Tablet / Device:
    Superpad
    OK, here is a little update

    Another post identified the LCD as a INNOLUX DISPLAY CORPORATION BT101 W01, according to the cut sheet
    my broken wire is #35 which is the Dimming signal input.
     
  4. terayop

    terayop Member

    Joined:
    Mar 27, 2012
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    60
    Location:
    Costa Rica
    Tablet / Device:
    SuperPad

    Hello, Mr, I realy need to buy this cable, do you knowk where can i buy it ??
     

Share This Page

Search tags for this page
30 pin out lcd tablet
,
android lcd connector
,
android mobile display pinouts
,
android mobile screen cable pinouts
,
display innolux pinout
,
flytouch 2 screen connector
,
innolux v236bj1 -xce2 cable pinout
,
lcd display connector pinout
,
lcd tablet display pinout
,
lcd tablet pinout
,
pin out lcd android
,
pin out of tablet lcd
,
pinout diagram for android tablet circuit board
,
pinout lcd display
,

superpad 2 monitor pinbelegung

,
tab display pinout
,
tablet display flat cable pinout
,
tablet display pinout
,

tablet lcd connector

,
tablet lcd pinout